PLUFIX Gas Heated Textile Dryers are ideal for the curing of inks after the screen printing process
Thanks to the “Actual Curing Time” feature; instead of belt speed value, the real curing time in the heat chamber is displayed on the operator's control panel
The speed and direction of the belts can be adjusted independently.
The portable operator control panel allows flexibility and ease of use
Using the “Temperature Calibration Page”, the dryer can be calibrated to show the actual garment temperature on the operator’s display.
In the event of electrical failure, the independent power supply will continue to run the belt for an additional 3-4 minutes
PLUFIX performs 6 separate safety checks each time it is started
The “Defect Seeking” system will display any fault on the operator’s panel and sound an alarm
Emergency stop safety buttons are located both on in-feed & out-feed conveyors and on the electric panel as well
Top quality control and gas equipment such as DUNGS, KROM SCHRODER, SIEMENS, SCHNEIDER, are used in PLUFIX
The PLC unit organizes and controls; Max-Min Gas Pressure, Blower Air Pressure, High Temperature, Ignition and Flame Control, Double Gas Filter and Double Solenoid, Gas Pressure and Volume Regulator as well as the control of all Motor Failures and Failure Resets
The FIBERFLON brand belts are heat resistant up to 250°C (482°F) and both sides are Kevlar® by DuPont™
Single belt and double belt models are available
Stainless steel entry & exit openings are adjustable
The temperature can be set up to 200°C (392°F)
Copyright Screen printing Machine and Supplies . All rights reserved. Screen Printing Machine Supplies Solar Pv Panel Inveter Batteries